![]() WHY WAS THIS STRAIGHT THROUGH CONNECTION POSSIBLE? The Straight Through Connection worked instead of the Cross over Cabling. Secondly I have to try the straight through cable (both side of the cable same color code), I connected one end to the system NIC (PC1) that is connected to my phone hotspot and I connected the other end to the second System NIC (PC2) without and internet connection (the goal is to make the other system to access Internet connection and all the services in the first laptop(PC1) and also share files and folders). This Article was great, well explained but sincerely I for one is a very pragmatic person in all that I do.Īm not an Author In Networking and Cabling but to find out the concept of straight through cabling and Cross over cabling, I have to try out this two scenarios to be sure of their application.įirst I tried out Straight Through on Unlike Devices, It was perfect and I do same using Cross over for like devices it was also perfect. If you are unsure of which to use, choose 568B. T568B has surpassed 568A and is seen as the default wiring scheme for twisted pair structured cabling. The first is the T568A wiring standard and the second is T568B. There are two standards recognized by ANSI, TIA and EIA for wiring Ethernet cables. ![]() A pinout is a specific arrangement of wires that dictate how the connector is terminated. Then, what’s the difference between them? Difference between straight-through and crossover cables will be introduced in this blog.Ī RJ45 connector is a modular 8 position, 8 pin connector used for terminating Cat5e or Cat6 twisted pair cable. Crossover cables are more commonly used to connect a computer to a computer and may be a little harder to find since they aren’t used nearly as much as straight-through cable. They are most likely what you will find when you go to your local computer store and buy a patch cable. The straight-through is the most common type and is used to connect computers to hubs or switches. All Rights Reserved.Ethernet cables can be wired as straight-through or crossover. Crossover cable is used to connect two like devices without the use of an uplink port.Ĭopyright © 2005 The Linux Information Project. It can also be used to directly connect like devices (e.g., two hubs or two switches) if the cable is plugged into an uplink port on one (but not both) of the devices. Straight-through cable is used to connect computers and other end-user devices (e.g., printers) to networking devices such as hubs and switches. However, this might be confusing in some situations because patch cable also has a broader definition that emphasizes the fact that there is a connector on each end rather than the equality (or lack thereof) of the pinouts. Straight-through cable is also commonly referred to as patch cable. ![]() ![]() It is identical to crossover cable, except that in the latter the wires on the cable are crossed over so that the receive signal pins on the connector on one end are connected to the transmit signal pins on the connector on the other end. Straight-through cable is a type of twisted pair copper wire cable for local area network (LAN) use for which the RJ-45 connectors at each end have the same pinout (i.e., arrangement of conductors). ![]() Straight-through cable: the opposite of crossover cable LINFO ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |